Securing Church Sacristy - Installing New Lock

 A long time and continuing client of ours contacted us last week to install their provided cam-lock to their church sacristy and wanted it keyed to suit their existing key, that operates other locks across their facility. The church already had their maintenance person install a barrel bolt to the fixed leaf of the proposed cupboard.

The difficulty was, they currently use a Ronis brand of cam-lock system in many of their other cupboards across other parts of their facility. They decided to purchase the particular cam-lock from a big box hardware, hoping it could easily be just keyed alike to their existing key. Ronis brand hardware is not a common brand of hardware found in many general supply houses or big box hardware stores and it can be difficult to re-key any old lock to their desired key.

A professional tradesperson will understand the requirements to be able to convert another brand of lock to operate with a different brand of key and often there is no way to perform the miracle and purchasing the same brand of lock is required. 

In this case, we immediately discovered that their desired key would not enter the key-way of the new lock. Being the trained and field experienced tradesman I am, i was able to modify the core to accept their desired Ronis key and could then re-key the core to the Ronis key combination.

We are choosing to not show the method we use to modify the chosen brand of core and below we will show you the installation procedure.

The first step in any installation project is to always protect the contents of the cupboard where you are working. Now, you can obviously empty the cupboard if you want, prior to beginning your work or you can choose to cover the contents with drop/cover sheets.

By using covering material to protect the contents of the cupboard, the valuable contents are protected, ensuring continued usability and cleanliness.

Again, the choice is for the installer or the site manager to make but in this case, they chose to just get it done and let the installer choose. 

It's very important that any installer of anything, be sure to accurately measure and mark before drilling anything at all. A professional will not just measure once, but probably 2-3 times, to ensure they are being as accurate as possible. It makes no sense to just do anything by eye or just wing it, as some DIY'ers might choose. If your customer is paying for a professional service, then do it the right way please.

I choose to pre-drill my first holes with a smaller drill bit, to enable me to make sure of my accuracy. If I'm out a bit, by using a smaller drill bit, i can still relocate my first hole if needed.

I like to start with a small hole drilled from the inside in the right location before switching to the outside and drilling too. This way I make a nice clean hole, generally without cracking the edges of the nicely finished and painted door.

After drilling a small hole from each side, I then can either use a spade bit or a hole saw of the appropriate size to drill the hole required for the case of the lock assembly.